Robica Forman Tank

Updated: 09/28/06

TC331/MC331/MC330

Tank Requirements
Inspection Form

Company Name:______________________		Date:___________________
Inspected By:_________________________	Truck #:__________	Tank Serial #:_____________

Item	Date of Tank Certification	Requirements		X
Metal I.D. Plate	All	Permanently attached to the tank or its supporting structure on the left or right (can be either depending on year of construction) side near the front
Stamping on I.D. Plate	All	The identification plate must be stamped with either:	TC331
			MC331
			MC330
(V) External Visual Inspection (M1)	All	Once per year (Three years from the last test But no later than Aug 15, 2003)
(K) Leakage Test (M1)	All	Once per year (First test no later than Aug 15, 2003)
(I) Internal Visual Inspection (M5)	All	Once every 5 Years (First test no later than Aug 15, 2003 if never performed in accordance to Standard- contact registered facility who performed last pressure test - M5 inspection)
(P) Pressure Test (M5)	All	Once every 5 Years
Liquid and Vapour Discharge Openings Less Than 1 1/4" NPT	All	Must be equipped with an excess flow valve and a manually operated external valve (approved ball valve)
Liquid and Vapour Discharge Openings of 1 1/4" NPT	Before Oct 1/84	Must be equipped with an excess flow valve and a manually operated external valve (approved ball valve) or internal shut-off valve (ISC valve)
Liquid and Vapour Discharge Openings 1 1/4" NPT or Larger	Between Oct 1/84 and Aug 15/02	Must be equipped with a remotely controlled internal shut-off valve (ISC valve or Flomatic®)
Liquid and Vapour Line and each Filling and Discharge Line for Liquid	New Unit After Aug 15/02	Must be equipped with a remotely controlled self- closing valve (ISC valve or Flomatic® with remote cable control or pheumatic control shut-down)
Engine Fuel Line Not Over 3/4" NPT	All	Must be equipped with an excess flow valve
Tanks 3501 USWGC and Larger	All	Must be equipped with two means of automatic closure installed outside the cab at the ends of the tank in diagonally opposing locations
Tanks 3500 USWGC and Less	All	Must be equipped with a means of automatic closure installed outside the cab at one end of the tank, away from the discharge connection area

For a printable copy of this form, click here

This document is a "Guide Only", and is not a comprehensive checklist for truck inspections. Please refer to
"B620/98 or 87" for complete requirements.

All tank inlets and outlets, except safety relief valves, shall be marked to designate whether they communicate with vapor or liquid when the tank is filled to the maximum permitted filling density. For example: a spray fill connection is considered a vapor valve because it communicates with the vapor space of the tank.